Pressure & Hydraulics Check
ScienceAssessmentGrade 7, 8Work out the lifting force of a hydraulic press, rank presses, load crates onto the right pistons, read a pressure in kPa, size a piston with the area of a circle, and compare work in with work out.
What students learn
- Use pressure = force ÷ area, passed on equally through a sealed liquid, to find the force on any piston of a hydraulic press.
- Use the area of a circle to size a piston that gives a needed force.
- Explain that a press trades distance for force: work in equals work out.
Standards
- MS-PS2-2
Plan an investigation to provide evidence that a change in an object's motion depends on the sum of the forces on it and its mass.
Misconceptions it spots
When you assign it, your report groups students by these.
- Uses r² for the area of a circle, leaving out π.
- Ranks presses by the big piston's area alone, ignoring the push and the small piston.
- Thinks the bigger piston moves further.
- Uses the circumference of a circle (the distance around it) for its area.
- Multiplies force by area to get pressure.
- Thinks a hydraulic press puts out more work than goes in.
- Divides the wrong way round (small area over big, or area over force).
- Gives a pressure in N/cm² where kPa were asked for.
- Stops at the pressure without multiplying by the area to get a force.
- Ranks presses by their push alone, ignoring the piston areas.
- Mixes up radius and diameter.
- Thinks both pistons push with the same force, instead of the same pressure.
- Thinks a narrower piston pushes harder than a wider one.
- Thinks work out is less than work in because the big piston moves less, ignoring its larger force.
Progress
- Item 1: not answered
- Item 2: not answered
- Item 3: not answered
- Item 4: not answered
- Item 5: not answered
- Item 6: not answered